Fast and Free Shipping On Orders Over $100
No Salesmen, Just Enthusiasts 888.993.4373
This is not your average dual stabilizer kit you see on 80's era Chevy's, not even close. The Carli Kit takes three of their products and combines them into a single kit to deliver a net effect greater than any stabilizer on the market.
HOW IT WORKS: As previously mentioned, this system works vastly different than your traditional dual stabilizer kits on the market. First, the kit starts with one of Carli's acclaimed High Mount Stabilizers that clamps to the drag link under the pitman arm and bolts to the sway bar mounting bracket. This applies pressure towards the drivers side.
Next, you get a low mount stabilizer, but instead of mounting it in the factory location, you're actually reversing its mounting. Instead of one end tied to the axle bracket at the passenger side and the other to a bracket on the center link tie rod, you're going to mount one end to the differential cover via the included bracket, and the other to the steering linkage. This change in mounting positions reverses the push you would get in the traditional location, now applying pressure towards the passenger side.
And further, out of all this, you also benefit from an indestructible differential cover that serves as the mounting provisions for the low mount stabilizer. Wow, that was a mouth full, but we promise....IT WORKS!
T-STYLE VS. Y-STYLE STEERING - You'll need to know what kind of steering you have. The easiest way to tell is to look at how your current stabilizer mounts. If you have a hole in the middle of the center link bar that the existing stabilizer mounts through via a tapered stud, then you have the Y-Style, but if you have a plate with two U-bolts, then you have the T-Style.
- ManufacturerCarli Suspension
- MPNCS-DSSOSK-T | CS-DSSOSK-T-STK | CS-DSSOSK-Y | CS-DSSOSK-Y-STK
- Carli Stainless Steel High Mount Stabilizer
- Carli Stainless Steel Low Mount Stabilizer
- Carli Differential Guard
- Carli Differential Guard Bracket
- High and Low Mount Stabilizers
- High Mount pushes toward Driver
- Low Mount Pushes Toward Passenger
NO VIDEOS AVAILABLE
- 0 Reviews
- 0 Questions
The Carli website lists 2 different versions of this kit; one for lifted trucks, and one for stock height. Which version is this and do you offer both? Also, is this compatible with a Mag-Hytec high capacity front diff cover??
The version on our site is for leveled to lifted trucks. It would only be compatible with the stock diff cover. If you needed one for a stock height truck we can get it. The difference according to Carli is the bracket for the upper stabilizer.