Fast and Free Shipping On Orders Over $100
No Salesmen, Just Enthusiasts 888.993.4373
Compressor Surge can be very damaging to a turbocharger due to the tremendous thrust load changes on the compressor wheel and shaft. The ATS Ported Shroud Compressor Housing is designed to increase your turbo life by eliminating the damaging effect of compressor surge. The ATS Ported Shroud Compressor Housing is designed with a 4" intake (stock is 3") and exclusive Inducer Bleed Ring. Utilizing a 4" intake results in a 13% increase in choke flow, allowing more air to flow into the compressor wheel. Inducer Bleed acts to broaden the range of the compressor wheel, smooth out air flow, and eliminate turbo compressor surge. While the ATS Ported Shroud Compressor Housing may cost more than other methods of fixing Compressor Surge (like a new compressor wheel), changing to the ATS housing doesn't require removal of the turbo or balancing of the rotating assembly. The savings in removal/installation time, downtime and the labor cost of turbo assembly balancing make the ATS Ported Shroud Compressor Housing an excellent choice for solving your compressor surge problem.
FEATURES & BENEFITS:
- Enlarged 4" inlet flows better with OEM wheel than merely upgrading the compressor wheel
- Increased turbo life
- Eliminates compressor surge
- 4" intake and exclusive inducer bleed ring
- 13% increase in airflow
- Smoother exit airflow
- Increased efficiency and performance
- ManufacturerATS Diesel Performance
NO VIDEOS AVAILABLE
- 0 Reviews
- 0 Questions
Is this something you can use for the Garrett GT38R or is this not necessary for that??
This is unnecessary on the GTP38R. -DK
Will this also need new compressor wheel.?
No it will not. You can use your factory wheel, or any upgraded wheel that is a direct replacement for the factory wheel. Most popular is the WickedWheel2. PN: WW38. -Ben
I am thinking about buying the banks quick turbo kit for my 01 7.3. Will this compressor housing bolt straight into that exhaust housing??
The exhaust housing and compressor housing are separated by the center section. That is what this attaches to. So as long as you are running a stock center section which is not changed with the quick spool housing you are fine. -Sands