Fast and Free Shipping On Orders Over $100
No Salesmen, Just Enthusiasts 888.993.4373
Bored of your stock Ford suspension and looking to upgrade to something that not only lifts your truck but also adds a more comfortable ride? This suspension system from BDS will show you superior performance for a value price.
This BDS kit for 2011-2016 6.7L Fords is designed and built around a massive tubular radius arm replacement. These arms are built to handle far more than the factory parts they are replacing. Designed with a factory style rubber bushing mount at the frame to keep the NVH (noise, vibration, and harshness) levels in check, you'll immediately notice a difference from your stock parts. The massive 3-1/4" diameter bushings have a maintenance-free service life. For easier installation the radius arms have been designed to mount right into the factory locations. Alignment cam locks are included that allow for caster adjust-ability, something your factory arms do not provide. In addition to adding 2.5" of lift the radius arms are geometrically set to keep the axle angle in factory specs.
And if massive, quality made radius arms are not enough, this system also features dual-rate front coil springs that improve the ride and handling of your truck both on and off the road. BDS' popular heavy-duty turnbuckle style adjustable track bar is included to center the axle. Front break line relocation brackets included along with your choice of BDS 5500-series or FOX 2.0 Performance Series shocks are available.
NX2 Series Shocks - BDS NX2 series gas shocks offer impressive performance on and offroad. They use a nitrogen charged, twin tube design with 10-stage velocity sensitive valving for lightning fast dampening and superior control.
Fox 2.0 Series Shocks - Fox 2.0 performance series shocks have been tuned and tested by both Fox and BDS Suspension to maximize performance specific to each application and to every BDS Suspension system. The basic shock design is based on proven Fox Racing Shox race products, but re-designed to maximize the ride quality, handling, and control of your BDS equipped truck, whether on or off the road.
The rear system utilizes a 4" block with an integrated bump stop wing to replace the factory 2" blocks, leveling out the back with the newly lifted front.Important Kit Notes
- For F250 Diesel models w/o top mounted overload rear springs.
- For F350 Models the 4" block is not needed to create a level stance as the factory block is already 3-7/8".
- For F250 and F350 choose 5" rear block kit if you desire a higher rake similar to that of the factory stance.
- ManufacturerBDS Suspension
Tire Wheel Combinations - 35" x 12.50 w/17" and 5" back spacing
Est. Installation: 5 hours
Difficulty Level (easy 1 - 5 complicated): 3
NO VIDEOS AVAILABLE