Fast and Free Shipping On Orders Over $100
No Salesmen, Just Enthusiasts 888.993.4373
If you're looking for additional power out of your Cummins, and your injectors are in good condition, we can upgrade them using the same procedure as when using new injectors, but at a fraction of the cost.
IMPORTANT NOTE: THIS LISTING IS FOR THE SERVICE TO UPGRADE YOUR EXISTING INJECTORS, NOT FOR NEW INJECTORS THAT HAVE ALREADY BEEN MODIFIED.
We have the capability to take stock injectors that will flow an average of 23 lpm (litres per minute) and run a media through it which will hone the nozzle to either 27 lpm or 29 lpm, depending on what we want the outcome to be. An injector flowed at 27 lpm will typically net an average of 50 horsepower over stock, and 29 lpm will produce about 90 horsepower over stock.
For those looking to gain some fuel economy and power, but not wanting to produce tons of power or have to upgrade the CP3 injection pump, then the 50 horsepower would be best suited. For those looking to gain appreciable power and are not opposed to upgrading the CP3 or at least install a Industrial Injection Bag-of-Parts CP3 Upgrade kit, then the 90 horsepower hone would be best.
If you are unsure of the integrity of your injectors, you can always send them in, because we will test them prior to honing to make sure they are not too badly worn.
But if you want to go the best way and get Bosch injectors, see below for pre-built, custom honed injectors. Under each variant is a drop down screen for you to choose what horsepower level you would like to see. There is no additional cost between 50 and 90 horsepower.
NOTE: These are a custom product that is produced as ordered, and will typically take several days for the modification process. Please contact us for lead times as these can vary.
- ManufacturerGeneric Manufacturer
NO VIDEOS AVAILABLE